We've discussed all the parts involved in the fabrication of the Cabinet Boxes.
Now I start to work up the face frame and finished end panel parts. ( basically all the Cherry components that get attached to the boxes.)
The part count for the face & panels is 153 this gives us a total of 331 parts on the list.
In this shot I have taken rough cherry stock flattened it, thickness planned it, straightened one edge, ripped it to the correct width and jointed the ripped edge to remove the saw marks on pieces that will have both edges exposed.
Now I start to work up the face frame and finished end panel parts. ( basically all the Cherry components that get attached to the boxes.)
The part count for the face & panels is 153 this gives us a total of 331 parts on the list.
In this shot I have taken rough cherry stock flattened it, thickness planned it, straightened one edge, ripped it to the correct width and jointed the ripped edge to remove the saw marks on pieces that will have both edges exposed.
From here these dimensioned pieces get cut to the exact length and beveled if necessary, tennons cut into the ends of some and groves or mortises into others, and the list goes on.
Pieces get assembled sanded and applied to the cabinet boxes.
Pieces get assembled sanded and applied to the cabinet boxes.
this is a wall unit actually standing on it's end, sanded and ready for finishing. (you're looking at the bottom of this unit.)
Other pieces get assembled into components that are part of the kitchen design. Here is the Island back wall that will be the eating area of the kitchen. ( this space is designed to accomodate 6 guests at the bar top.)
RSS Feed
